Sapphire Plug-ins for AVX2: Dissolve

S_Dissolve A basic cross fade between two input clips. In the Sapphire Transitions category. Inputs: From: Starts the transition with this clip. To: Ends the transition with this clip.

Parameters:

Load Preset: Push-button .
Brings up the Preset Browser to browse all available presets for this effect.

Save Preset: Push-button .
Brings up the Preset Save dialog to save a preset for this effect.

Dissolve Amount: Default: 0, Range: 0 to 1.
The transition ratio between the From and To inputs. Auto Trans must be disabled for this parameter to be used. This would normally be animated from 0 to 1 to perform a complete transition, and the curve can be adjusted for more detailed control over the timing of the dissolve. The Slow In and Slow Out parameters, if positive, also adjust the transition ratio internally for a smoother start and/or end to the transition.

Dissolve Speed: Default: 1, Range: 1 or greater.
The speed of the dissolve between the From and To clips. When set to 1, the dissolve takes place over the entire duration of the effect. When set higher, the dissolve is shorter, although the glow ramp-up and ramp-down still takes the entire duration. Setting this to 10 can make the transition snappier and more like a flash-frame cut.

See general info for: Crop/Transform , Resolution , Bypass Effect , and Reset .

See Also:

DissolveStatic DissolveSpeckle DissolveDiffuse DissolveBubble DissolveWaves DissolvePuddle DissolveVortex DissolveBlur DissolveDefocus DissolveLuma DissolveFilm DissolveDistort DissolveTiles DissolveGlow DissolveLensFlare DissolveEdgeRays DissolveGlint DissolveGlintRainbow

Sapphire Plug-ins Introduction