Sapphire Plug-ins for AVX2: DissolveFilm

S_DissolveFilm Transitions between two input clips using a film dissolve with selectable gamma. Film dissolve preserves the highlights in the clips longer compared to a regular dissolve. The Dissolve Amount parameter should be animated to control the transition speed. In the Sapphire Transitions category. Inputs: From: Starts the transition with this clip. To: Ends the transition with this clip.

Parameters:

Load Preset: Push-button .
Brings up the Preset Browser to browse all available presets for this effect.

Save Preset: Push-button .
Brings up the Preset Save dialog to save a preset for this effect.

Dissolve Amount: Default: 0, Range: 0 to 1.
The transition ratio between the From and To inputs. A value of 0 gives only the From input and a value of 1 gives only the To input. By default this parameter automatically animates from 0 to 1 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the dissolve. In the AVX1 version, Auto Trans must be disabled for this parameter to be used.

Gamma: Default: 2, Range: 0.1 or greater.
The film gamma to use for the dissolve. Higher values preserve more highlights.

See general info for: Crop/Transform , Resolution , Clamp Output To Legal , Bypass Effect , and Reset .

See Also:

DissolveStatic DissolveSpeckle DissolveDiffuse DissolveBubble DissolveWaves DissolvePuddle DissolveVortex DissolveBlur DissolveDefocus DissolveLuma DissolveDistort DissolveTiles DissolveGlow DissolveLensFlare DissolveEdgeRays DissolveGlint DissolveGlintRainbow

Sapphire Plug-ins Introduction